Table of Contents
Advertisement
6 Troubleshooting
This section describes commonly encountered
issues and accompanying solutions.
Disconnect the power cable from the power
Check that the power cable is securely
connected.
The remote control is not working properly:
Check that the remote control batteries
are correctly inserted according to the +/-
orientation.
Replace the remote control batteries if they are
flat or weak.
Disconnect the power cable from the power
reconnecting the power cable. If the blinking
reoccurs, contact Philips Consumer Care.
Enter '8202'.
No action is required. The creaking sound is
cools down and warms up. This does not impact
performance.
18 EN
Previously installed channels do not appear in
the channel list:
Check that the correct channel list is
selected.
6.3 Picture issues
Check that the antenna is properly
Check that the correct device is selected
There is sound but no picture:
Check that the picture settings are
correctly set.
connection:
Check that the antenna is properly
Loudspeakers, unearthed audio devices,
neon lights, high buildings and other large
objects can influence reception quality.
If possible, try to improve the reception
quality by changing the antenna direction
If reception on only one channel is poor,
fine tune this channel.
There is poor picture quality from connected
devices:
Check that the devices are connected
properly.
Check that the picture settings are
correctly set.
flexibility to change and save settings.
The picture does not fit the screen; it is too
big or too small:
The picture position is incorrect:
Picture signals from some devices may
not fit the screen correctly. Check the
signal output of the device.
Advertisement
Table of Contents
