Advertisement
ISO DIN MOUNT: (DIN-E RADIO WITH SIDE MOUNTING HOLES)
1. Snap the ISO DIN side mounting brackets to the back of the mounting panel (1 left and 1 right). Use
supplied hardware to bolt them to the back of the kit panel.
2. Load the radio from the REAR of the mountinfg panel until the nosepiece of the radio comes
through the front of the kit.
3. Use the 5mm screws to secure the radio from the sides.
CAUTION:
Rear supporting the
radio adds to the
installation's structural
integrity.
ACCENT
MOUNTING
PANEL
2000-up Hyundai Accent
RADIO REMOVAL:
1. Open cup holder and extract (2) Phillips head screws from behind.
2. Unsnap and remove the left and right accessory button covers and extract 91) Phillips head screws
behind each cover.
3. Open glovebox and release stoppers so that glove box is hanging down and release (1) cable from
behind.
4. From above gas pedal, release (2) cables.
5. Carefully unsnap perimeter of dash bezel and slowly remove dash bezel. Disconnect and remove.
2000-up Hyundai Sonata
RADIO REMOVAL:
1. Unsnap panel in front of shifter, lift away and remove. Extract (2) Phillips head screws from behind.
2. Put shifter in lower gear, unsnap shifter trim bezel and remove.
3. Extract (2) Phillips head screws from beneath radio dash bezel.
4. Underneath left side of glove box, disconnect cable.
5. Using panel removal tool, unsnap radio bezel, unplug and remove.
ISO DIN MOUNT
ISO
MOUNTING
BRACKET
ISO DIN RADIO
5MM SCREWS
Advertisement
