Cleaning And Maintenance; Daily Cleaning - ResMed Flow Generator S8 Elite System Illustration Manual

C
LEANING AND
You should regularly carry out the cleaning and maintenance described in this section.
Refer to your mask manual for detailed instructions.
D C
AILY LEANING
M
ASK
Clean the mask according to the instructions supplied with the mask.
A
IR TUBING
Disconnect the air tubing from the
tubing and mask in a clean, dry place until next use.
H
UMIDIFIER
If you are using a humidifier, remove it from the
instructions in the humidifier user's manual.
W C
EEKLY LEANING
1. Remove the air tubing from the
2. Wash the air tubing in warm water using mild detergent. Rinse thoroughly, hang,
and allow to dry.
3. Before next use, assemble the mask and headgear according to the user
instructions.
4. Reconnect the air tubing to the air outlet and mask.
P C
ERIODIC LEANING
1. Clean the exterior of the
2. Check the air filter for blockage or holes (see "Replacing the Air Filter" on
page 26).
WARNING
!
Beware of electric shock. Do not immerse the unit or power cord in water.
•
Always unplug the unit before cleaning and be sure it is dry before plugging back
in.
The mask system and air tubing are subject to normal wear and tear. Inspect
•
them regularly for damage.
M
AINTENANCE
S8 E
LITE
S8 E
LITE
with a damp cloth and mild liquid soap.
S8 E
LITE
(and humidifier, if used) and hang the
and clean it according to the
S8 E
LITE
and the mask.
C
LEANING AND
25
M
AINTENANCE