HP ZBook x2 Maintenance And Service Manual page 83

Nonvolatile
memory type Amount (Size)
Intel Management 1.5 MBytes or
Engine Firmware 7 MBytes
(present in only
specific ZBook and
EliteBook models.
For more
information, go to
http://www.hp.com/
support, and select
your country.
Select Drivers &
Downloads, and
then follow the on-
screen
instructions.)
Bluetooth flash 2 Mbit
(select
products only)
802.11 WLAN 4 Kbit to 8 Kbit
EEPROM
Webcam (select 64 Kbit
products only)
Fingerprint reader 512 KByte flash
(select
products only)
Does this Does this
memory memory
store retain data
customer when power
data? is removed?
Yes Yes
No Yes
No Yes
No Yes
Yes Yes
What is the
purpose of this How is data input into this
memory? memory?
Stores Management Engine Code is
Management programmed at the factory.
Engine Code, Code is updated via Intel
Settings, secure firmware update utility.
Provisioning Unique Provisioning Data can
Data and iAMT be entered at the factory or by
third-party data an administrator using the
store. Management Engine (MEBx)
setup utility. The third-party
data store contents can be
populated by a remote
management console or local
applications that have been
registered by an administrator
to have access to the space.
Stores Bluetooth flash is
Bluetooth programmed at the factory.
configuration Tools for writing data to this
and firmware. memory are not publicly
available but can be obtained
from the silicon vendor.
Stores 802.11 WLAN EEPROM is
configuration programmed at the factory.
and calibration Tools for writing data to this
data. memory are not made public.
Stores webcam Webcam memory is
configuration programmed using a utility
and firmware. from the device manufacturer
that can be run from
Windows.
Stores Fingerprint reader memory is
fingerprint programmed by user
templates. enrollment in HP ProtectTools
Security Manager.
How is this memory write-
protected?
follow the on-screen
instructions.
The Intel chipset is
configured to enforce
hardware protection to
block all direct read/write
access to this area. An
Intel utility is required for
updating the firmware.
Only firmware updates
digitally signed by Intel
can be applied using this
utility.
A utility is required for
writing data to this
memory and is made
available through newer
versions of the driver
whenever the flash
requires an upgrade.
A utility is required for
writing data to this
memory and is usually not
made available to the
public unless a firmware
upgrade is necessary to
address a unique issue.
A utility is required for
writing data to this
memory and is usually not
made available to the
public unless a firmware
upgrade is necessary to
address a unique issue.
Only a digitally signed
application can make the
call to write to the flash.
Nonvolatile memory usage 75