Speakers - HP ZBook x2 Maintenance And Service Manual

3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
following components:
a. Front-facing webcam/microphone module (see
on page
b. Battery (see
c. System board (see
Remove the solid-state drive:
1. Position the system board upside down with the rear edge toward you.
2. Release the Mylar shield (1) that secures the solid-state drive to the system board.
3. Remove the Phillips M2.0×3.0 screw (2) that secures the drive to the system board. (The solid-state drive
tilts up.)
4. Remove the solid-state drive (3) by pulling it away from the connector.
NOTE:
Reverse this procedure to install the solid-state drive.

Speakers

Description
Speakers (includes left and right speakers and cables)
Before removing the speakers, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
56 Chapter 5 Removal and replacement procedures
43)
Battery on page
System board on page
Solid-state drives are designed with notches to prevent incorrect insertion.
Display panel assembly on page
Front-facing webcam/microphone module
40)
47)
30), and then remove the
Spare part number
L03253-001