Table of Contents
Advertisement
Chapter 3 Installation and Configuration
The S5U13517P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm resistors which allow it to
be used with a variety of different configurations.
3.1 Configuration DIP Switch
The S1D13517 has 2 configuration inputs (CNF[1:0]). A DIP switch (SW1) is used to configure CNF[1:0] as
described below.
SDU13517P00C100
SW1-[2:1] Config
CNF[1:0] Config
SW1-[1]
SW1-[2]
= Required settings when using S5U13U00P00C100 USB Adapter board
The following figure shows the location of DIP switch SW1 on the S5U13517P00C100 board.
DIP Switch
SW1
S5U13517P00C100 Evaluation Board User Manual (Rev. 1.0)
Table 3-1: Summary of Power-On/Reset Options
S1D13517
CNF0
Host data bus is 8-bit
CNF1
Host interface is ALE bus
Figure 3-1: Configuration DIP Switch (SW1) Location
Power-On/Reset State
1 (ON)
EPSON
S1D13517 Display Controller
0 (OFF)
Host data bus is 16-bit
Host interface is i80 bus
7
Advertisement
Table of Contents
