Remington Protect & Shine CB-75i Use & Care Manual

SPECIAL FEATURE THIS CURLING BRUSH CAN ALSO BE USED
This brush features solid-state electronic
AS A 3/4" CURLING IRON BY REMOVING
circuitry with a heat sensor that detects THE CURLING BRUSH ATTACHMENT
temperature loss and quickly boosts the 1. Unplug the unit and let it cool completely.
power to bring the heat level back to 2. Remove brush attachment by holding the unit
optimum styling temperature. This allows firmly by the handle and sliding off Curling Brush.
for styling in half the time it takes with an
3. Plug in and let heat.
ordinary brush. FOLLOW THE SAME INSTRUCTIONS IN THIS
BOOK WHEN USING UNIT AS A CURLING IRON.
This appliance is designed to operate on
120/240 volts, 50/60 Hz. It is not intend- HOW TO GET PROFESSIONAL RESULTS
ed for commercial use. Hair should be WITH YOUR CURLING BRUSH
clean, dry or nearly dry, and free of tan- This unique curling brush has been designed with
gles before using. multiple temperatures, providing very high heat in
the Hl (25-30) settings for curling very coarse,
HOW TO USE thick, hard-to-curl hair, and very low heat in the
For complete styling, hair should be clean, LO (1-6) settings for curling extra fine, damaged
dry and free from dirt, hair spray, creams,
or dry hair. It also provides a full range of heat
etc. (This curling brush can also be used settings between LO and HI, for all normal
for quick touch-ups any time.)
textures and thicknesses of hair.
1. Rest the curling brush on a smooth,
TEST A SMALL SECTION OF HAIR BEFORE
flat surface, and plug it in.
USING; THEN ADJUST TEMPERATURE
2. Press ON/OFF switch, and the power
DEPENDING ON TYPE OF HAIR.
indicator light will flash.
3. Select a temperature according to the
HEAT SETTINGS
type and texture of hair to be styled.
WARNING
4. With heat control dial set at desired
This multiple temperature curling brush has been
position, allow unit to pre-heat. The
specially designed to curl very coarse, thick, hard-
power indicator light will begin to
to-curl hair. Due to this special application, the
flash to signal that appliance is heat-
barrel of this curling brush will be hotter on the HI
ing up. When appliance is fullly heat-
(25-30) settings than regular dual-heat curling
ed the indicator light will stop flash-
brushes. Due to the extreme capabilities of
ing. Note: For optimum styling per-
formance, let the brush continue to this brush, the barrel will be very hot in the
heat for about 2 minutes before using. HI (25-30) settings, so extra care should be
taken when using.
• Keep unit away from contact with all skin STYLING
areas. Do not touch barrel with fingertips.
1. Taking one section at a time, use the curling
• For shorter hair, place a thin plastic comb brush to roll hair in the direction of the curl
between scalp and curling brush to avoid
desired, and hold a few seconds.
touching scalp.
2. When using as a curling iron, take one sec-
• Place fingers of free hand on safety tip when
tion at a time, lift clamp and place end of hair
more control is needed under the clamp so that it extends a little past
for curling.
the clamp. Release clamp so that it closes
• Test small section of hair to
over the end of the hair. Roll hair in desired
determine correct heat setting for
direction and hold for a few seconds.
the type of hair being styled.
3. The cool tip can be a great help in winding.
Use one hand on the handle and the fingers
HI (25-30)
of the other on the cool tip.
These settings are very hot. Use only if hair
NOTE: To avoid tangling, do not wind
is very coarse and highly resistant, but in
hair around the curling brush more
good condition.
than two times.
MED/HI (19-24)
3. When hair feels warm, the curl is set.
Use heat settings in this range for dense,
4. Carefully remove curling brush and allow
hard-to-curl hair in good condition.
curl to cool without disturbing it.
5. Continue steps 1-4 all over your head.
MEDIUM (13-18)
6. When you achieve your desired style, use
Use heat settings in this range for thick, wavy hair
the hot brush to brush hair into place.
in good condition.
7. Afterward, once all curls have cooled thor-
LO/MED (7-12)
oughly, gently brush and comb hair into the
Use heat settings in this range for easy-to-curl,
style desired.
normal hair.
STYLING TIPS
LO (1-6)
Use LO heat setting for very fine, fragile, damaged For a Flip, take a 2" section of hair and roll
light-colored hair.
the brush up over the hair.
For a Curl, take a 2" section of hair and roll
the brush under the hair.
For Volume and Body, roll hair loosely
around the brush. Allow hair to cool slightly
before brushing.
AUTO-OFF USER MAINTENANCE
INSTRUCTIONS
After approximately one hour, the unit will
automatically shut itself off. To reactivate 1. To clean the unit, be sure it is cool
the unit, press ON/OFF switch. and unplugged. Wipe handle,
barrel and curling brush with a
DUAL VOLTAGE USE damp cloth. No other maintenance
is necessary.
This product contains a special electronic circuit.
2. When not in use, store appliance
This circuit automatically adjusts to worldwide
where it will not become damaged.
voltage. When traveling overseas, this product
Do not wrap cord around
can be plugged into any voltage outlet without
appliance.
your having to adjust the product manually in any
3. Do not attempt to repair the appliance
way. In some overseas countries, an attachment
yourself. Return to Remington
plug adapter of the proper configuration for the
power supply receptacle may be required. DO Customer Service Center for repair.
NOT USE a voltage converter or extension cord
STORAGE:
with this product.
When not in use, unplug the unit. Allow it
to cool and store out of reach of children in
a safe, dry location.
Never wrap the cord around the appliance
as this will cause the cord to wear prema-
turely and break. Handle cord carefully
and avoid jerking it, twisting or straining it,
especially at plug connections.
®
P S
ROTECT& HINE
TM
Curling Brush and Iron
with 3X Protection
+
Ceramic
+
Ions
for beautiful, healthy,
shiny hair
CB-75i