Playing With Digital Sound (Transacoustic Mode) - Yamaha TransAcoustic TA2 Owner's Manual

Playing with digital sound (TransAcoustic mode)

You can play with the digital sound and hear it through resonance of the soundboard of the piano by the
TransAcoustic technology. The acoustic piano sound does not sound.
1 Rotate the [VOLUME] control to the far-left
position to set the volume to minimum.
2
Press the [P] (Standby/On) switch to turn the power on.
3
Stop the acoustic piano sound by one of the following operations.
For upright pianos equipped with a sostenuto pedal
• Pull the silencing lever towards you until you
hear a click and feel the mechanism catch.
For upright pianos not equipped with a sostenuto pedal
• Press the center pedal and slide it to the left.
For grand pianos
• Make sure that the [Aco.] lamp is
turned off.
If the lamp is lit, press the [VOLUME] control
to turn it off.
4
Rotate the [VOLUME] control to the
right slightly and make sure that the
[TA] lamp lights up.
NOTE
When the volume is set to minimum, when the Voice is
set to "---" (Off; page 21), or when headphones are
connected, the [TA] lamp does not light up.
5
While playing the keyboard, adjust the volume level by rotating the [VOLUME]
control.
Rotating to the right increases the volume, while rotating to the left decreases it.
NOTE
The physical sound of the keyboard mechanism remains even when playing in the TransAcoustic mode.
18
TA2 Owner's Manual
Off
Lights up