Sunlawn MM-1 Owner's Manual

Manual reel mower

Advertisement

Quick Links

Owner's Manual
for
Manual Reel Mower
(Model MM-1)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MM-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sunlawn MM-1

  • Page 1 Owner’s Manual ™ Manual Reel Mower (Model MM-1)
  • Page 2 ™ Sunlawn, Inc. 325 Garfield Street Fort Collins, CO 80524 Tel: 970-493-5284 FAX: 970-493-5202 For service inquiries, parts replacement, and maintenance tips, see www.sunlawn.com © 2006 by Sunlawn, Inc...
  • Page 3: Warranty

    BEFORE USING THE NEW MANUAL REEL MOWER Please read this guide and use these operating instructions to become familiar with the mower and its features. The notes on safety and maintenance procedures are important for the use and enjoyment of this product.
  • Page 4: Parts List

    PARTS LIST Please check when unpacking the unit to be sure that all items listed below are included: Mower 3 handle sections (1 each upper, middle, lower) C. 4 handle bolts D. 4 wing nuts Stainless steel blade adjustment gauge Roller apron with mounting screws (not shown) See Mowing Using The Grass Catcher section, pages 4-5.
  • Page 5: Operation

    ADJUSTING THE CUTTING HEIGHT The cutting height of the MM-1 may be adjusted from approximately 1/2 inch up to approximately 2 1/4 inches. Actual height may vary according to the height of the turf. Adjust the mower to the desired height as follows: 1.
  • Page 6: Starting And Operation

    2. Set the height, using the scale on the back of the roller arms, to the same setting on both sides and re-tighten the black knobs. The mower is now ready to mow at the desired height setting. STARTING AND OPERATION WARNING •...
  • Page 7: Mowing: General Information

    If the lawn is overgrown (to higher than 4-5 inches) it may be advisable to use a brush cutter to remove the excess turf mass before resuming mowing at normal heights. Owner’s Manual — Sunlawn MM-1...
  • Page 8: Maintenance

    Sharpening can only be done by a professional using a cylinder grinder and proper techniques. STORAGE 1. Store the MM-1 in a cool, dry place. 2. The mower should be stored out of the reach of children. READJUSTING THE BLADE CLEARANCE The blades are optimally adjusted from the factory.
  • Page 9 3. Make the same adjustment at the other end of the cutting bar. 4. Now check the adjustment using the small 0.05mm gauge (silver strip) supplied with the MM-1 (or any 0.05mm feeler gauge). If the gauge is held by the cylinder blades but the cylinder and cutting bar are not touching then the adjustment is correct.
  • Page 10: Technical Data

    Owner’s Manual — Sunlawn MM--1 Mower Cutting width: Weight with battery: Cutting height rough (from floor): .4 to 2.2 inches TECHNICAL DATA 40 cm 35.2 lb...

Table of Contents