Mounting Position; Mounting Positions Of Components - REXROTH IndraDrive Project Planning Manual

62/309 Bosch Rexroth AG
General Data and Specifications
Description
Maximum concentration of corrosive gases
Vibration sine: Amplitude (peak-peak) at
10 ... 57 Hz
1)
Vibration sine: Acceleration at 57 ... 150 Hz
Vibration noise (random) frequency
Vibration noise (random) spectral acceleration
density, amplitude 1)
Vibration noise (random) rms value of total ac‐
celeration 1)
Vibration sine: Axial
Acceleration at 10 ... 2,000 Hz
For KMS: Axial (A), radial (R)
Vibration sine: Radial
Acceleration at 10 ... 2,000 Hz
Overvoltage category
5.3.2

Mounting Position

Mounting Positions of Components

Mounting Positions
Rexroth IndraDrive Drive Systems with HMV01/02 HMS01/02, HMD01, HCS02/03
Symbol
1)
1)
2)
2)
1) According to EN 60068-2-64
2) According to EN 60068-2-6
3) Reduced performance data for drive controllers: Allowed DC bus con‐
tinuous power, braking resistor continuous power, continuous current
4) Reduced performance data for motors: Performance, torque S1 and
S3
Tab.5-7: Ambient and Operating Conditions (KSM, KMS)
NOTICE
Only operate the components in their allowed mounting positions. The al‐
lowed mounting positions are specified in the technical data of the compo‐
nents.
The only mounting position allowed for supply units and drive controllers to
be installed in control cabinets is G1.
The technical data of the components specifies the allowed mounting posi‐
tions as G1, G2, G3, G4, or G5.
DOK-INDRV*-SYSTEM*****-PR06-EN-P
Unit
According to degree of protection
mm
g
Hz
g 2 /Hz
g
g
With accessory HAS10.1-001-001-NN:
g
With accessory HAS10.1-001-001-NN:
III (according to IEC60664-1)
Risk of damage to the components by incor‐
rect mounting position!
Value
-
-
-
-
-
1
KSM: 1
KMS: 3
1
KSM: 3
KMS: 3