FILA FILActive 38-113 User Manual

1

Design of the Watch

Thank you for purchasing this watch.
Please read this manual thoroughly before using the watch!
Hour
Hand
Stopwatch
Minute Hand
Second
Hand
Stopwatch
Second Hand
2

Specifications

• Time Module VD53
• Chronograph with date
• Stainless steel case and leather strap / silicon strap
• 5 ATM
* These specifications might be changed without prior notice.
3

Date and Time Setting

N 1
1.
N 1 2
2. - 3.
N 1 2 3
4.
NOTE
- Before setting the time, check the stopwatch second and
minute hands are in the '0' (12 o'clock) position. Please see
next chapter for details.
- Do not set the date hand between 9:00p.m. and 1:00a.m.
Otherwise, it may not turn properly. If it is necessary to set the
date during that time period, change the time to any time
outside it, set the date and then reset the correct time.
- When the crown is at the position 3. Do not press any button.
Otherwise, the chronograph hands will move.
Minute
Hand
Stopwatch
Start /Stop
[A]
24 Hour
Hand
N 1 2
Stopwatch
Split /Reset
[B]
N: Normal
Date
1: Unlock
2: Adjust date
3: Adjust hands
1. Turn the crown counter
clockwise to unlock.
2. Pull out the crown to the
position 2.
3. Turn the crown clockwise to
adjust the date.
4. Pull out the crown to the
position 3 when the second
hand is at the 12 o'clock
position. It will stop on the
spot and rotate the hour and
minute hands by turning the
crown. (Check the 24 hour
hand is set correctly.)
5. Push the crown back in to the
normal position in accordance
with a time signal.
6. Push and turn the crown
clockwise to lock.
3
FILActive
38-113
www.fila.com/watch
4

Resetting Stopwatch Position Hands

Please do one of the following steps to reset the stopwatch
hand.
1. - Stopwatch is stopped: Press [B] to reset the stopwatch
1/10 second, second and minute hands to "0" position.
- Stopwatch is counting: Press [A] to stop counting then
press [B] to reset all stopwatch hands.
- Split time is displayed: Press [B] to release split time, [A]
to stop counting then press [B] to reset the stopwatch.
If either of the stopwatch hands are not in the "0" position, reset
them according to the procedure below.
1. Turn the crown counter clockwise to unlock.
2. Pull out the crown to the position 3.
3. Press [A] or [B] to reset the stopwatch second and minute
hands to "0" position.
4. Push the crown back to the normal position.
5. Push and turn the crown clockwise to lock.
Note: By pressing [A], the hands move counter clockwise. By
pressing [B], the hands move clockwise.
User
MANUAL
FM-750.1
[A]
N
[B]
1.
[A]
N 1 2 3
[B]
1. - 4.