Junction Box Wiring Terminals For Remote Style Meters - Sage SIP Operation And Instruction Manual

24 S A G E M E T E R I N G , I N C .
Junction Box Wiring Terminals for Remote Style Meters (Series SRP)
(THERE ARE NO ELECTRONICS INSIDE JUNCTION BOX)
SEE THE PREVIOUS PAGE FOR THE OTHER END OF THE REMOTE WIRING HOOKUP (the electronics side).
CUSTOMER SIDE
(Wired at Installation Site)
Grounding Screw
GROUNDING SCREW NOT USED
(The shield [drain wire] is only connected
on the other end [the electronics end]).
4.37
Metal Conduit
is recommended
with appropriate
grounding to
minimize effects
from external
noise sources.
To Terminal A1 to A6
(see page 21–23)
NOTE: The Sensor Junction Box
will have a serial number tag.
It is important to match this serial
number with the serial number
of the Remote electronics. Mixing
components from different meters
can result in significant errors.
1 NOTE: There are hidden jumpers (underneath the terminal strip) that short together the Blue
and Green wires, and also short together the Black and Orange wires. These extra wires are part
of the meter's Lead Length Compensation circuitry, allowing the user to change the length of the
interconnect cable (from 0 to 1000 feet) without effecting the accuracy. 25 feet of cable are ini-
tially supplied (for cabling longer than 1000 feet, contact Sage).
CAUTION: Cable and cable glands are not for use in hazardous area
a
environments. Power, ground, outputs, shielded cable, seal fittings
and conduits are to be supplied by customer.
REV. 16-SIP/SRP
O p e r a t i o n s a n d I n s t r u c t i o n M a n u a l
Blue
Green
1
Red
Orange
Black
White
3/4" FNPT
Conduit Receptacle
2
Interconnect Cable
2 Sage supplies 25 feet of cable for the interconnect wires between the Junction Box and the Remote
Enclosures: Carroll (manufacturer), Part #C0783, 20 gauge, 6 conductor, foil shielded, grey PVC jacket.
CAUTION: Strip wires 3/8" and
do not crimp insulation.
Red
FACTORY SIDE
Red
White
(Wired at Factory)
White