Motors With Planetary Gears; Characteristics Of Sp+ Series - Siemens SINAMICS S120 Configuration Manual

Gearbox

9.2 Motors with planetary gears

9.2 Motors with planetary gears
9.2.1

Characteristics of SP+ series

Overview
1FK7 motors can be combined with planetary gears to form compact coaxial drive units.
The gearboxes are flanged directly to the drive end of the motors.
When selecting the gearboxes, ensure that the permissible speed of the gearbox is not
exceeded by the maximum speed of the motor. In the case of high operating frequencies,
allowance must be made for the withstand ratio
The frictional losses of the gearbox must always be taken into account when engineering
geared drives.
The gearboxes are only available in a non-balanced design.
Benefits
• High efficiency:
• Minimum torsional play:
• Power transmission from the central sun wheel to the planetary pinions
• No shaft deflections in the planetary pinions set due to the symmetrical force distribution
• Very low moment of inertia and hence short acceleration times of the motors
• Output shaft bearings dimensioned for high cantilever and axial loads with preloaded
• The gearboxes are connected to the motor shaft via an integrated clamping hub A plain
• Output shaft of gearbox exactly coaxial with the motor
• The gearboxes are sealed (seal between the gearbox and motor) and filled with oil at
the factory. They are lubricated for life and sealed. Gearboxes of frame sizes SP060S to
SP180S are suitable for all mounting positions.
• For gearboxes, sizes SP210 and SP240 the quantity of oil in the gearbox depends on
the mounting position. The mounting position has to be specified when ordering.
• Gearbox degree of protection IP65 (IP64 for frame sizes SP210 and SP240)
• Small dimensions
• Low weight
194
> 97% single-stage
> 94% 2-stage
≤ 4 arcmin single-stage
≤ 6 arcmin 2-stage
tapered-roller bearings
motor shaft end is necessary for this purpose. Radial eccentricity tolerance N in
accordance with DIN 42955 and vibration severity grade A in accordance with
EN 60034-14 are sufficient. The motor flange is adapted via adapter plates.
f
.
2
Configuration Manual, (PFK7S), Edition 12.2006, 6SN1197-0AD16-0BP1
Synchronous Motors 1FK7