Sanyo MCH-900F Instruction Manual page 12

12.
Press the MEMORY button.
"CF?E@l" remains lit.
- The maximum number of selections that can be pro-
grammed is 32. If you try to enter more selections,
"FULL" will appear on the display.
Checking the program
1.
2.
While in the stop mode, press the MEMORY button.
The disc, track and program numbers will appear on
the display.
Press the MEMORY button again toviewthe disc, track
and program numbers for the other programmed selec-
tions.
These displays do not appear during programmed
play.
Press the l button to start Dlav.
When all programmed selections have played, the CD
changer stops automatically.
The program contents are retained in memory.
NOTE:
The program is cleared in the following cases:
- When the OPEN/CLOSE button is pressed.
When the STOP/CLEAR button is pressed in the stop
mode.
When the mains lead has been disconnected and the
backup batteries are discharged or not installed.
Changing a program
To add a new selection to a program:
1. In the stop mode, press the MEMORY button repeat-
edly until the following display appears:
" - -- -- _"
2. Select a disc and track number as explained above.
Note:
If you program a track on the disc that was pro-
grammed last, press the w or button to select
the track. The disc number will be selected automati-
cally.
To change a selection
1. Press the MEMORY button repeatedly until the selec-
tion to be replaced is displayed.
2.' Select a disc and track number as explained above.
WHAT TO DO IF ...
If "CH Err" appears on the display.
1. Press the POWER button to turn the power off.
2. Press the POWER button to turn the power on.
If the operation of the unit or display is not normal,
even though the appropriate buttons have been
pressed.
1.
2.
3.
4.
Disconnect the AC mains lead and remove the batter-
ies (if applicable).
Press the RESET button (rear of the unit) for at least
20 seconds. (See Page 5.)
Connect the AC mains lead and install the batteries
(if applicable).
Press the desired function button.
NOTE:
If the unit does not operate correctly, or "CH Err" appears
again, please contact your nearest Sanyo Authorized
Service Center.
-11-