Getting Started; Charging The Battery; Connect Cables; Fitting Headset And Eartips - Honeywell QUIETPRO QP100Ex User Manual

2 Getting started

2.1 Charging the battery

Connect the charger to the control unit and fully charge the battery before use. It takes approximately
4 hours to fully charge the battery. For further instructions regarding battery charging, see section 11.

2.2 Connect cables

Connect the cable from the headset to the connector on the control unit marked [HEADSET]. Connect the
radio cable to the communication radio and then to the connector on the control unit marked [COM].
TIP There is a red dot on the connectors to show you how to align the connectors.
! NOTE The radio cable plug has a locking mechanism. To release the connector make sure you take hold
of the locking ring and then pull straight out. By pulling the cable instead of the locking ring, the
cable may be damaged.
! NOTE Depending on your radio(s), there may be connectors with locking mechanisms also in the radio
end of the cable.

2.3 Fitting headset and eartips

A proper fit of eartips ensures good comfort during prolonged use. The eartips are therefore provided in
several different sizes.
TIP Insertion of the eartips and the comfort of the fitting improve with practice. Honeywell recommends
getting help from a QUIETPRO-trained instructor or experienced user to learn how to insert the tips in
the best way.
1. Compress the foam by rolling it into a small
crease-free cylinder.
3. Reach around your head and gently pull the ear
to straighten the earcanal.
HONEYWELL SAFETY PRODUCTS
2. Fit the eartip to the earpiece. Make sure the tip
fully covers the pipes.
4. Push the eartip into the earcanal while gently
twisting the earpiece. There is a difference between
the left and the right hand side earpieces.
A marking on the earpiece and cable will show you
which earpiece is made for which ear.
9