Table of Contents
Advertisement
Quick Links
Product
Part#
Steve's Bench
# RTS90DGMxx
NOTE: The monitors and monitor arms are not included.
Toll-free: 800.325.3841 | Fax: 800.325.0045 | email: sales@anthro.com | anthro.com
A S S E MB LY I NSTRUCTIO N S
Steve's Bench
10450 SW Manhasset Dr. | Tualatin, OR 97062
Outside the U.S. | Tel: 503.691.2556 | Fax: 503.691.2409
June 2016 Rev. A
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Anthro Steve's Bench RTS90DGM Series
Summary of Contents for Anthro Steve's Bench RTS90DGM Series
- Page 1 NOTE: The monitors and monitor arms are not included. 10450 SW Manhasset Dr. | Tualatin, OR 97062 Toll-free: 800.325.3841 | Fax: 800.325.0045 | email: sales@anthro.com | anthro.com Outside the U.S. | Tel: 503.691.2556 | Fax: 503.691.2409 June 2016 Rev. A...
- Page 2 25 Spacer Plate 225-6093-00 12 3.2M Power Cord For Control Box 400-5181-00 26 Keypad Housing 400-5358-00 (Not Shown) 27 Anthro 5/32" Hex Driver (Not Shown) 375-5000-00 13 Leg Cable (Not Shown) 400-5182-00 28 5/32 Hex Driver Bit (Not Shown) 375-5003-00 14 Keypad 400-5357-00 29 Hex Key 1/8"...
- Page 3 ƒ Loosely attach the front of each leg assembly to the worksurface with three more #10-9 x 1” Hex Button Head PB Screws using the Anthro driver. ƒ Do not fully tighten screws yet. This will come at the end of the assembly.
- Page 4 ƒ Install two cable clips into the large holes next to the leg and under the cable trough. Route the leg cords through the cable clips. 3/4” Phillips Screw Cable Snap-in Clip 325-5370-00 175-51 1 88-00 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
- Page 5 8" up from the top of the foot. ƒ Align the cross pan with the nut plate on the each leg assembly so the Anthro logo faces the front of the table, close to the shelf. ƒ Attach the cross pan to each leg assembly with two M5-0.80 Nylock Nuts using a 5/16"...
- Page 6 Warranty: For warranty information, please visit: www.anthro.com/support/warranty Notices: Technology Furniture® and Steve's Bench® are trademarks of Anthro. Anthro reserves the right to modify the design and specifications without prior notice. Anthro Corporation is a wholly owned subsidiary of Ergotron Inc., a Nortek company...
Need help?
Do you have a question about the Steve's Bench RTS90DGM Series and is the answer not in the manual?
Questions and answers