Application Window - Siemens SIMATIC S5 Manual

Parameterizing, saving and documenting the configuration with COM ET 200 Windows
Building the
ET 200
configuration
8-6
Build your ET 200 configuration in the application window:
1. Begin by entering the parameters for the bus, the host and the DP master.
See Sections 8.2.1 through 8.2.3 for details.
2. After entering the parameters, in the "Slaves" window click on the DP
slave that you want to parameterize, e.g. ET 200 ( ).
Result: The icon for the DP slave you selected is attached to the mouse
pointer.
3. Click on the point representing the end of the bus, thus dropping the slave
and attaching it to the bus ( ).
Result: COM ET 200 Windows prompts you for the station number of
this DP slave.
4. Select a station number and confirm by pressing the "OK" button.
Result: The "Slave parameters" dialog box is opened.
5. Enter the slave parameters. See Section 8.2.4 for details. Repeat steps 2
through 4 until you have generated all the DP slaves for this master
system.
6. Close configuration of the DP slaves by clicking on the arrow in the
"Slaves" pop-up menu ( ).
Master system: station number 1
Bus designation: PROFIBUS-DP
Host designation: S5-135U host
Station type: IM 308-C
Station number: 1
Station designation:
Figure 8-1

Application window

Slaves
ET 200
SIMATIC
DRIVES
AS-I
OTHERS
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a