Power Connector Port; Audio Board - Dell Precision 5530 Service Manual

Power connector port

Removing the DC-in Connector
1 Follow the procedures in
2 Remove the:
a base cover
b battery
3 Perform the following steps to remove the I/O board:
a Disconnect the DC-in cable from the connector to the system board [1].
b Remove the M2x3 screw that secures the DC-in connector to the computer [2].
c Lift the DC-in connector from the computer [3].
Installing the DC-in Adapter Port
1 Place the DC-in adapter port into the slot on the palm-rest assembly.
2 Route the power-adapter port cable through its routing guides on the palm-rest assembly.
3 Replace the M2x3 screw that secures the power-adapter port to the palm-rest assembly.
4 Connect the power-adapter port cable to the system board.
5 Install the:
a Battery
b Base cover
6 Follow the procedures in

Audio board

Removing Audio board
1 Follow the procedures in
2 Remove the:
28 Disassembly and reassembly
Before Working Inside Your
After Working Inside Your Computer.
Before Working Inside Your
Computer.
Computer.