Panasonic AW-RP50 Manual page 3

■ Turning ON Remote Camera by Turning ON AW-RP50 Power Supply
＊ You can turn ON the camera connected via IP ([Network]) or serial ([Serial]) connection by turning ON the power
switch of AW-RP50 controller.
1．Turn the MENU button – (Fig.6-A) ON. (Its LED lights up.)
2．Press the LED button 8 (CAMERA) – (Fig.6-B) at PRESET MEMORY/MENU area.
3．Turn F1 dial – (Fig.6-C) to display [2] POWER menu – (Fig.7), and press F1 dial.
4．Turn F1 dial – (Fig.6-C) to display 2. AUTO ON menu – (Fig.7).
5．Turn F2 dial – (Fig.6-D) to select [On], and press F2 dial. * Default: [On]
(Figure 6: AW-RP50 Control Panel)
（B）
（A）
<Note>
・ Make sure that the remote camera is in STANDBY mode when AW-RP50 controller is turned ON.
・ AW-RP50 controller does not have the function of switching the remote camera to STANDBY mode by turning OFF
its power switch.
Rear Panel: AW-RP50 Power SW
(Figure 7: AW-RP50 LCD Panel)
Press Button 8
（C）
[1]GROUP
（D）
Turn F1
[2]POWER
Turn F1
1．CAM POWER
ALL OFF ↓
Turn F1
2．AUTO ON
Turn F1
2．AUTO ON
Press F2
Oｆｆ ↓
On ↓