Electrical Connections - Zanussi ZCE569NW1 Instruction Book

Electrical connections

Any electrical work required to install
this hob and the supply cable should be
carried out by a qualified electrician or
competent person, in accordance with the
current regulations.
THIS COOKER MUST BE EARTHED
The manufacturer declines any liability
should these safety measures not be
observed.
This cooker is designed to be connected to a
230/400V, 50Hz electrical supply.
To connect to the electricity supply, use cable
type H05 RR-F.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the rating plate.
The cooker is supplied without supply cord. A
flexible supply cord must be fitted, in accordance
with the specification gived in the relevant table
no. 1.
In case of a direct connection to the mains you
have to interpose an omnipolar switch with a
minimum opening between contacts of 3 mm
must be done under over voltage category III
condition
The switch should be sited within 2m of the hob
and be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be
interrupted by the switch.
NOTE: The earth wire should be about 10-12 cm
longer than the live and neutral wires.
22
Ensure that the cooker supply cable
does not come into contact with any part of
the hatched area shown in the diagram.
If the supply cord is damaged, it
must be replaced by the manufacturer or its
service agent or a similarly qualified person
in order to avoid a hazard.
Before connecting check that:
• fuse and household electric installation can
bear the charge of the appliance (see
rating plate);
• The socket or the omnipolar switch used
for connection is easily reachable when the
appliance is installed.
How to proceed?
• Unscrew and remove the protective cover
at the back of the appliance;
• Connect the power cord to the terminal of
the cooker according to the table no.1;
• Fix by means of cable clamp;
• Make sure that the connection to the
terminal is matching the network power;
Remount and screw the protective cover at the
back of the appliance
supply
cable