Maintenance - Makita 3620 Instruction Manual

Templet guide (optional accessory)
(Fig. 12, 13 & 14)
The templet guide provides a sleeve through which
the bit passes, allowing use of the router with templet
patterns.
To install the templet guide, loosen the screws on the
tool base, insert the templet guide and then tighten
the screws.
Secure the templet to the workpiece. Place the tool
on the templet and move the tool with the templet
guide sliding along the side of the templet.
Vacuum head set (optional accessory)
(Fig. 15, 16 & 17)
When you wish to perform clean cutting operation,
use this vacuum head. Install the vacuum head on
the router base using the two screws and connect a
vacuum cleaner to the vacuum head.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 92 dB (A)
sound power level: 103 dB (A)
Uncertainty is 3 dB (A).
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of standard-
ized documents,
EN60745, EN55014, EN61000
in accordance with Council Directives, 89/336/EEC and
98/37/EC.
Yasuhiko Kanzaki
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
ENG005-2-V3
2
.
CE 2005
Director
ENH101-5
9