Advertisement
You need two pairs of speaker pins
(available at your local RadioShack store)
to make the connection.
Follow these steps to connect the wires to
each terminal using speaker pins.
1. Separate the conductors for a length
of about 2 inches on the end of each
1
wire. Then strip
/
inch of insulation
2
from the ends of each conductor and
twist the wire ends.
2. Position each wire end between the
open barrel ends of the speaker pin.
To PRO-SW220P
From Left or Right Speaker
3. Using a pair of pliers, crimp the open
barrel ends of the speaker pin to hold
the wire ends in place.
4. Plug the speaker pin into the proper
terminal on the PRO-SW220P .
C C C C O O O O NN
NN
NNE E E E C C C C T T T T I I I I NG
NN
NG T T T T O O O O P P P P O O O O W W W W E E E E R R R R
NG
NG
Plug the PRO-SW220P's AC power cord
into an AC outlet.The
STANDBY
lights green. If the subwoofer does not
receive a signal for about 11 minutes the
STANDBY
A A A A D D D D J J J J U U U U S S S S T T T T I I I I N N N N G G G G T T T T H H H H E E E E V V V V O O O O L L L L U U U U M M M M E E E E
Once you have made all connections,
follow these steps to adjust the PRO-
SW220P' s volume.
1. Rotate
2. Turn on your amplifier/receiver and
another component (such as a radio,
cassette player, CD player, or
turntable).
3. Begin playing an audio source (such
as a radio) and adjust the amplifier/
speaker' s overall volume to a
comfortable level. Rotate VOLUME
CONTROL
clockwise a little at a time, until you
achieve a pleasing balance of bass
between the PRO-SW220P and the
main speakers (and satellite speakers,
indicator
if used). Bass output should not
overpower the main speakers, but
should blend across the entire musical
range.
5
indicator lights red.
to
VOLUME CONTROL
on the PRO-SW220P
.
MIN
Advertisement
