Part
Drum Removal
Sensor
(Thermistor,
Thermostat)
Removal
10 _ Disassembly and Reassembly
复件 Hudson_Dryer_SM_E.indb 18
figure
1. Disconnect the Power Supply to the unit.
2. Remove the Panel Control, the Main PCB, the
Cover Top, the Frame Front and the Drum Front.
3. Remove Belt.
4. Remove the Drum.
When reassemble the belt, make it located
1. Disconnect the power supply to the unit.
2. Remove the Panel Control, the Main PCB, the
Cover Top, the Frame Front, the Drum Front and
the Drum.
3. Remove 2 Housing Sensor.
4. Remove the Sensor.
Do not apply excessive force to the terminal.
Description
middle of the Drum.
2012-4-2 15:20:53