Download  Print this page

Turns Off While Playing; Noisy Stereo Reception - RCA MM27110 User Manual

Multimedia monitor.
Hide thumbs


Horizontal or diagonal lines on screen
In some cases, the computer and monitor may not be synchronized properly. To set the correct resolution for your
monitor you should consult your operating system's owner's manual on how to "boot" your system up into the "safe
mode" and set monitor display for the desired mode (such as SVGA 800x600 Progressive).
Black box appears on the screen
Captioning may be turned on and in text mode. Check the Closed-Caption Display control panel in the Channel menu.
No sound, picture okay
Maybe the sound is muted. Try pressing the volume up button to restore sound.
Maybe the speakers are turned off. Check the Audio Output and Speakers control panel in the Audio menu.
If using an S-VHS component, remember to also connect the component's L and R AUDIO OUT jacks to the TV's L and R
INPUT jacks.
Check the INT/EXT switch on the back of the monitor.
Can't select certain channel
Channel may be blocked or not approved in the Parental Controls menu.
If using a VCR, check to make sure the TV/VCR switch on the VCR is in the correct position.

Turns off while playing

Electronic protection circuit may have been activated because of a power surge. Wait 30 seconds and then turn on
again. If this happens frequently, the voltage in your house may be abnormally high or low.
Maybe sleep timer is set.
Unplug. Wait five minutes. Plug in again.

Noisy stereo reception

May be a weak station. Use Audio menu to choose mono sound.
No picture, no sound but TV is on
Maybe the cable/air function is set to the wrong position.
Maybe a vacant channel is tuned.
If watching a VCR (connected only through antenna input), make sure your TV is tuned to channel 3 or 4—the same as
the CH3/4 switch on your VCR. Also check to make sure the TV/VCR switch on your VCR is in the correct position.


   Also See for RCA MM27110

   Related Manuals for RCA MM27110

This manual also for:


Comments to this Manuals

Symbols: 0
Latest comments: