Updating The Firmware; Motion Controller Vibrations And Constellation Leds Behavior - Lenovo Explorer User Manual

Updating the firmware

Connect the Lenovo Explorer headset to your computer and pair the controller with your
computer. If the latest controller firmware is available, the firmware will be downloaded to
the controller and installed automatically the next time you turn on the controller. During the
installation process, controller LEDs are illuminated and keep blinking in a circular motion
for 1-2 minutes. After the firmware update is completed, the controller will restart and
reconnected to the headset.
Motion controller vibrations and constellation LEDs
behavior
The motion controller vibrations and constellation LEDs indicate the status of the motion
controller.
Motion controller
status
Turning on or paired
Turning off
Sleep
Pairing
Paring failed or time-
out
Disconnected from
computer
Battery power low
Firmware update
Notes:
• The motion controller enters sleep mode if it is idle for over 30 seconds. The motion
controller automatically wakes up when it detects motion.
• The motion controller turns off automatically if it is idle for over three minutes.
• You can check the battery status by the battery-status icon on the motion controller in
mixed reality. The icon is red when the battery power is low.
4
Motion controller
vibrations
Once
Twice
─
─
Three times
Once
Twice
─
Constellation LEDs behavior
On
Off
Blink every three seconds
Pulse slowly
Blink three times
Blink once
• Blink twice if the battery power is
low.
• Blink three times if the battery
power is critically low.
Blink in a circular pattern