Track Number - Sanyo MCH-S970F Instruction Manual

12. Press the MEMORY button.
II m f remains lit.
~–----
DISC TRACK
%
lEm -
MEMORY
:1 /:. I /:. _ /+
_l~ll_ II
Programming can also be performed using the re-
mote control. Use the DISC SELECT button to select
the disc, and the " M/+ " and " */M " buttons or
TRACK NUMBER buttons to select the tracks.
The maximum number of selections that can be pro-
grammed is 32. If you try to enter more selections,
"FULL" will appear on the display.
Checking the program
1.
2.
While in the stop mode, press the MEMORY button.
The disc, track and program numbers will appear on
the display.
Press the MEMORY button again to view the disc,
track and program numbers fortheother programmed
selections.
These displays do notappearduring programmed
play.
Press the PLAY/PAUSE button to start play.
When all programmed selections have played, the CD
changer stops automatically.
The program contents are retained in memory.
NOTE:
The program is cleared in the following cases:
When the OPEN/CLOSE button is pressed.
When the STOP/CLEAR button is pressed in the stop
mode.
When the mains lead has been disconnected and the
backup batteries are discharged or not installed.
Changing a program
To add a new selection to a program:
1. In the stop mode, press the MEMORY button repeat-
edly until the following display appears:
,, ,,
-- -- --
2. Select a disc and track number as explained above.
Note:
If you program a track on the disc that was pro-
grammed
last, press the " M " or " m " button to
select the track. The disc number will be selected
automatically.
To change a selection
1.
Press the MEMORY button repeatedly until the selec-
tion to be replaced is displayed.
2. Select a disc and track number as explained above.
--
WHAT TO DO IF ...
-"-"~
If "CH Errr' appears on the display.
1.
Press the POWER button to turn the power off.
2. Press the POWER button to turn the power on.
If the operation of the unit or display is not normal,
even though the appropriate buttons have been
~ pressed.
: 1. Disconnect the AC mains lead and remove the
batteries (if applicable).
: 2.
3.
; 4.
Press the RESET button (rear of the unit) for at least
20 seconds. (See Page 7.)
Connect the AC mains lead and install the batteries
(if applicable).
Press the desired function button.
NOTE:
; If the unit does not operate correctly, or "CH Err"
~ appears again, please contact your nearest Sanyo ~
! Authorized Service Center.
.—
-13-