Advertisement
remote controls
1
1/5. VOLUME +/- buttons
4
2/4.
2
5
3.
STANDBY/ON
3
6
6.
PLAY/PAUSE
Using the remote control correctly
• Point the remote control at the REMOTE SENSOR located on the unit.
• When there is a strong ambient light source, the performance of the infrared
REMOTE SENSOR may be degraded, causing unreliable operation.
• The recommended maximum effective distance for remote operation is about 16 feet
(5 meters).
attentIon
to change Battery
Remove the protective plastic tab
1. Open the battery door.
before operating the remote control.
2. Insert one CR2025 (3V) size battery.
Battery replacement
When the battery becomes weak, the operating distance of the remote control is greatly
reduced and you will need to replace it.
note: If the remote control is not going to be used for a long time, remove the battery
to avoid damage caused by battery leakage corrosion.
WarnInGS:
• Do not dispose of battery in fire; battery may explode or leak.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Danger of explosion would be resulted if battery is incorrectly replaced. Replace only
with the same or equivalent type of battery.
caUtIon: When discarding batteries, environmental problems must be considered and
local rules or laws governing the disposal of these batteries must be strictly followed.
Volume adjustment
to aDJUSt tHe VoLUme
Adjust the VOLUME control to obtain the desired volume.
for perSonaL LIStenInG
Connect headphones ( Ø3.5mm stereo mini plug) to the PHONES jack. Adjust the
VOLUME control to obtain the desired volume.
When headphones are connected, the speakers are automatically disconnected.
Listening to your ipod
compatible ipod types
• iPod nano (1st generation) 1GB, 2GB, 4GB
• iPod nano (2nd generation) 2GB, 4GB, 8GB
• iPod nano 3rd generation (video) 4GB, 8GB
• iPod mini 4GB, 6GB
/
buttons
• iPod 5th generation (video) 30GB, 60GB, 80GB
/ button
• iPod classic 80GB, 160GB
button
• iPod touch 8GB, 16GB,32GB
Installing the ipod Dock adaptor
1. Before connecting your iPod, you need to install the
appropriate iPod Dock Adapter(supplied with the
iPod or sold separately) in the dock of the unit.
2. Insert your iPod Dock Adapter into the dock until it
sits firmly in place.
removing the
1. Remove the iPod Dock Adapter as illustrated in the
figure to the right.
2. Replace it with another one you need.
Inserting your ipod
1. Ensure the appropriate iPod Docking Adapter is
installed.
2. Insert your iPod into the connector in the dock.
Start playback
1. Press the StanDBy/on
2. Press the pLay/paUSe
note: When you are listening to iPod, please disconnect all other audio devices.
notes:
• Under AC power supply, the iPod will be charged automatically.
• Under battery operation, the iPod will not be charged.
pausing playback
• Press the pLay/paUSe
• To resume playback, press the pLay/paUSe
Skipping to a another track
• Press the
track. Press the
Locating a particular point on a track
• Keep either the
direction, and release at the desired point.
note: Please refer to the user's guide that was included with your iPod for more details.
aUX In connection
connecting to aUX In for other sound sources
You can connect audio devices such as your iPod, CD players or MP3 players to the unit
through the AUX IN jack. Use the Line-in cable (not supplied), connect the AUX IN jack
on the back panel to the Line Out or Earphone jack of the other audio devices.
Listening to the connected Device
Turn on the audio device you have attached to the AUX IN jack.
ipod Dock adaptor
/ button to turn on the unit.
button to start playing.
button.
button again.
button to skip to the beginning of the current track or skip to previous
button to skip to the beginning of the next track.
or
button pressed during playback, according to the desired
more information
Troubleshooting tips
Cleaning the exterior
System doesn't turn on
•
Disconnect the system from AC
•
Unplug the unit for a moment,
power before cleaning the exterior
and then plug it back in.
of the unit with a soft dust cloth.
•
Check the outlet by plugging in
•
Clean the exterior with a soft clean
another device.
cloth or slightly moistened chamois
leather. DO NOT use solvents as it
no sound
may cause damage to the unit.
•
Adjust volume setting.
•
Make sure you've selected the
correct function.
ipod does not start play
•
Make sure the iPod is properly
connec ted to the universal
dock for iPod.
The descriptions and characteristics in this
owner's manual are for the purpose of general
eSD remark:
reference only and not as a guarantee.
I n c a s e o f m i s f u n c t i o n d u e t o
In order to provide you with the highest
electrostatic discharge just reset
quality product, we may make changes
t h e p r o d u c t ( d i s c o n n e c t a n d
or modifications without prior notice. The
reconnect of the power source may
English version serves as the final reference
on all product and operational details should
be required) to resume normal
any discrepancies arise in other languages.
operation.
Specifications
DC: 12V EXTERNAL DC SUPPLY
BATTERY SUPPLY: 1.5Vx6 "C" SIZE/UM-2/LR14/MN1400
Design and specifications are subject to change without notice.
Printed in China
811-R50391W011
Advertisement
