Plug In The Tv; Put Batteries In The Remote; Turn On The Tv; Use The Remote Control To Complete The Assisted Setup - RCA SCENIUM HDLP50W151 User Manual

Plug in the TV

Plug the flat end of the cable into the power jack on the back of the TV. Then plug the other end
of the power cord into an appropriate wall outlet. Be sure to insert the plug completely. Do not
plug into an outlet controlled by a light switch.
Note: When you first plug your TV into an outlet, the Power indicator on the front panel
will light for approximately 15 seconds and then go off during the initialization of the TV.
The TV can only be turned on after the Power indicator goes off. This happens every time
power is reapplied to the TV.
Tip
When remote batteries are low, the component
button(s) corresponding to the mode you're in
flashes when you press a button. Also, a
message might appear on the TV screen and
disappear within a few seconds. Press CLEAR to
remove.
ON-OFF
TV
DVD VCR
SAT CAB AUX AUDIO
PIP PIP SWAP SWAP CH. CTRL CH. CTRL SKIP SKIP
SOUND SOUND FREEZE FREEZE VCR PLUS+ LIGHT LIGHT
VCR+
FORMAT FORMAT INFO INFO
MENU MENU
CLEAR CLEAR
Chapter 1

Put Batteries in the Remote

• Remove the battery compartment cover from the back of the remote
by pushing down on the tab and lifting cover.
• Insert 2 fresh "AA" batteries. Make sure the polarities (+ and -) are
aligned correctly.
• Replace the cover.

Turn on the TV

Press TV on the remote, or press POWER on the TV's front panel.
Note: Pressing the TV button turns on the TV and puts the remote
into TV mode. "TV mode" means that the buttons on the remote
control operate the TV's functions.
Use the Remote Control to Complete
the Assisted Setup
The technical term is "Navigation" – how you move through the on-
screen menus. The method is the same throughout the menu screens:
highlight your choice and select it.
To highlight a menu item, put the remote into TV mode by pressing the
TV button
TV button then MENU. Press the arrow buttons on the remote to highlight
one of the items listed in the menu. Use the up or down arrow button to
move up or down. Use the right or left arrow button to move right or left.
To select the item that you've highlighted, press OK.
Note: Highlighted means that the menu item stands out from
other menu items on the list (appears darker, brighter, or a
different color).
MENU button
OK button
Arrow buttons
Connections & Setup
25