Why You Should Connect The G-Link Cable; How To Find The Remote Sensor; Placing The G-Link Wands - RCA SCENIUM HDLP50W151 User Manual

Why You Should Connect the G-LINK Cable

The G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program guide) to
work with your VCR and/or cable box.
Cable Box – If your TV is connected to a cable box, you must connect the G-LINK cable to receive
TV program listings for your area and to tune directly to a channel when the program guide is on
your TV screen.
VCR – If your TV is connected to a VCR and you don't connect the G-LINK cable, one-touch VCR
recording and timed recordings won't work. The other features of the guide will work properly.
G-LINK cable
G-LINK wands
Tips
If you have both a VCR
and a cable box, it
doesn't matter which
wand is connected to
which box.
If you don't have both a
cable box and a VCR
connected to your TV,
just coil the cable of the
extra G-LINK wand with a
twist tie and leave it
behind the TV.
Chapter 1

How to Find the Remote Sensor

You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box.
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn't
labeled on your VCR and/or cable box, you need to use the remote control that came with the
VCR and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, but the one that came with the
cable box and/or VCR to which you're attaching the G-LINK cable) so that it is touching the
front of the component.
3. Slowly move the remote control across the front of the component (VCR or cable box) while
you press the power button on and off. You must press and release the power button each
time you move the remote (holding down the button won't work).
VCR
4. When the component turns on, you've located the VCR's or cable box's remote sensor.

Placing the G-LINK Wands

Place the G-LINK wands in front of the remote sensor on your VCR and/or cable box
approximately one inch away from the remote sensor (see below).
Connections & Setup
RIGHT LEFT FIXED/VARIABLE
AUDIO
OUTPUT CENTER CHANNEL INPUT
EXTERNAL AMPLIFIER
MAXIMUM POWER RATING!
SPEAKER INTERNAL
(60 WATTS into 8 OHMS)
SELECT SPEAKER
SOURCE
INT W/ R
EXT
EXT SURR TV EXT AMP
L
EXTERNAL SPEAKERS
VIDEO VIDEO VIDEO VIDEO
INPUT 1 INPUT 2 INPUT 3 INPUT 4
V V V V
P P
R R
S-VIDEO S-VIDEO
L/ MONO L/ MONO L/ MONO P B L/ MONO P B L/ MONO
R R R Y R Y R
AUDIO AUDIO AUDIO AUDIO AUDIO
INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5
RECORD
OUTPUT
VIDEO
ANTENNA A ANTENNA B
INPUT INPUT
AUDIO
DIGITAL
AUDIO
OUTPUT ETHERNET
R
L G-LINK
Connect to G-LINK jack
on the back of the TV
.
VCR
SENSOR
CABLE BOX
CHANNEL
TV
VIDEO
INPUT 5
DVI-HDTV
CHANNEL
SENSOR
03
03
23