Deleting Recordings/Files From Usb/Mmc; Replacing The Fuse; Troubleshooting - Silvercrest KH 2381 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

• If necessary start playback of the external audio
device.
SCAN/REC
• Hold down the
The notice REC MMC or REC USB appears.
SCAN/REC
• Press the
button several times to select
either the recording option USB (Recording to a
USB memory medium) or MMC (Recording to an
SD/MMC memory card).
• Start the copy process by pressing the button
BD/ENT
BAND/ENTER
(
on the remote control).
• To stop recording, briefly press the button
BAND/ENTER
(
on the remote control) again. The
display changes to indicate the recording source
and the recording is saved.
Information regarding the recorded
data
The recording will be saved to the data carrier
with the following notations:
Audio CD recordings:
MP3-CD recordings:
Radio recordings:
AUX recordings:
Audio CD and radio recordings are recorded
in stereo and with a bitrate of 128 kbps
and/or a sampling frequency of 44 kHz.
When copying MP3 files the recording format
of the copy source will be adopted.
Deleting recordings/files from
USB/MMC
You can delete recordings or files stored in
MP3/WMA format on a USB or SD/MMC data
carrier.
LD/MD
• Press the button
control) to switch to USB or SD/MMC mode,
depending on where the file you would like to
delete is located.
• Select the file and hold the
for about two seconds. The display shows DELETE.
BD/ENT
• Press the button
trol) to delete the current file from the data carrier.
Once the deletion process is finished, playback
continues with the next title.
button.
BD/ENT
Track01, Track02 ...
Music01, Music02 ...
Tuner01, Tuner02 ...
Line01, Line02 ...
MODE/LOUD
(
on the remote
SCAN/REC
button pressed
BAND/ENTER
(
on the remote con-
Note:
Deleting of the file cannot be undone!
• If you do not wish to delete the file, press the
LD/MD
MODE/LOUD
button
(
wait about 5 seconds until the notice DELETE
disappears from the display.

Replacing the fuse

The car radio is equipped with a 10 A fuse on the
rear panel, which blows if a voltage peak or a short
circuit should occur.
• In this case replace the fuse with one of equal
value and of the same type as listed in the technical
data with the same trip characteristics.
• Have an expert investigate the reason for tripping
of the fuse before switching the car radio on
again.

Troubleshooting

The device will not switch on
The ignition is not switched on
• Switch the ignition on by turning the key.
The fuse is defective.
• Replace the fuse.
The CD will not load or eject
A CD is already inserted into the car radio.
• Remove the CD.
The CD has been inserted the wrong way up.
• Insert the CD with the labelled side up.
The CD is dirty or defective.
• Clean the CD or insert a different CD.
The temperature in the vehicle is too high.
• Wait until the surrounding temperature has
normalized.
Condensation on the laser lens
• Switch the car radio off for a few hours and
then try it again.
- 18 -
on the remote control) or

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents