Operation; Basic Operation; Volume; Bass/Treble/Balance/Fader - Silvercrest KH 2381 Operating Instructions Manual

Operation

Operation via the buttons on the
device and on the remote control
Most of the functions can be operated by the
buttons on the device as well as by the cor-
responding buttons on the remote control. The
buttons on the device are described in these
instructions. If the buttons on the remote control
are meant this will be specifically mentioned.
Instead of pressing the multi controller described
in the manual, it is also possible to use the
button on the remote control.
Instead of turning the multi controller left or
right, it is also possible to use the
buttons on the remote control.
Note
Approx. 5 seconds after a setting has been
made the playback will again be displayed
and the setting is saved.

Basic operation

Switching On and Off
Briefly press the button
remote control) to switch on the radio. In the display
the notice WELCOME appears.
PWR/DIM
• Briefly touch the
play illumination.
To switch off, hold down the
The notice GOOD BYE appears in the display.

Volume

• Turn the multi controller to increase or decrease
the volume.
Attention!
Always set the volume to a level that will allow
you, at any time, to clearly hear acoustical
signals from emergency service vehicles!
VOL-
and
PWR/DIM POWER/DIM
( on the
button to dim the dis-
PWR/DIM
button longer.
MUTE - Switch off the sound
Press the button
switch off the sound. The message MUTE appears
on the display.
To switch the sound back on, press the button
again or turn the multi controller. The MUTE indicator
goes out.

Bass/Treble/Balance/Fader

• Press the multi controller to display the current
settings for volume (VOL) bass (BAS), treble
(TRE), balance (BAL) and fader (FAD).
• Turn the multi controller to change the settings.
SEL
Note
When the DSP equalizer is on, the settings
VOL+
for BASS and TREBLE are not available.

Loudness

• Hold the button
control) pressed to switch the loudness function
on or off.
When the loudness function is switched on, LOUD
ON is shown in the display, and LOUD OFF is
shown when the loudness function is switched off.

Display

• By pressing the
notices in the display around in the following
manner:
With radio reception:
PS (Programme name), time of day (will automati-
cally be set with RDS reception), PTY settings (these
RDS functions are transmitted by the broadcast institu-
tions in various extents; see also the chapter "Radio func-
tions") and frequencies.
In CD mode:
Time, PTY settings, frequency and PS (Programme
name).
- 10 -
MU MUTE
( on the remote control) to
LD/MD MODE/LOUD
( on the remote
DISP
button you can switch the
MU