Menu Settings; Shut Off; Filter; Start Calc'n'clean - Siemens TE502...DE series Instruction Manual

Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
i lter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.

Menu settings

You can adapt the appliance to your indi­
vidual needs in the menu settings.
e
1. Hold the off /
at least 3 seconds.
e
2. Press the off /
edly until the required menu item ap­
pears in the display.
3. Select the required setting with the up­
per rotary knob (14).
4. Coni rm by pressing the start button
(10).
To leave the menu without making any
changes, turn the rotary selector to
and press the start button (10).
You can set the following:
: Here you can set the time span

Shut off

after which the appliance automatically
switches off following the last drink prepara­
tion. A time between 15 minutes and 4
hours can be set. The default time is 1 hour,
but this can be shortened to save energy.
: Here you can set whether a water

Filter

i lter is being used. If a water i lter is not
being used, turn the setting to
If a water i lter is being used, turn the set­
ting to
Activate filter
have to be rinsed before use (see "Water
i lter" on page 24).
TE502_1DE.indb 25
button (12) down for
j
button (12) repeat­
j
Exit
.
No / Old
. New water i lters

Start Calc'n'Clean

grammes (
Calc'n'Clean
) can be selected manually here.
cleaning
Press the start button (10) and run the se­
lected programme (see "Service
Programmes" on page 31).
: The brewing temperature (

Temp.

/ ) can be set here.
middle low
: The display language can be

Language

set here.
: The water hardness

Water hardness

setting can be adjusted on this appliance. It
is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting for the
water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your lo­
cal water supplier.
Dip the test strip briel y in water, gently
shake off any drips, and check the result
after one minute.
Level Water hardness
German (°dH)
1 1­7
2 8­14
3 15­21
4 22­30
en de
: The service pro­
/ /
descaling
/
high
French (°fH)
1­13
14­25
26­38
39­54
25
29.08.2011 12:11:31