Table of Contents
Advertisement
Chapter 1
Things to consider before you connect
Protect components from overheating
•
Don't block ventilation holes on any of the components. Arrange the components so that air
can circulate freely.
•
Don't stack components.
•
When you place components in a stand, make sure you allow adequate ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf.
Position cables properly to avoid audio interference
•
Insert each cable firmly into the designated jack.
•
If you place components above the TV, route all cables down the side of the back of the TV
instead of straight down the middle of the back of the TV.
•
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead
cables away from audio/video cables.
Note: Some discs may not be compatible due to laser pickup and disc design.
Install Batteries in the Remote
1
1. Remove the battery compartment cover.
2. Insert the batteries (provided), by matching the diagram in the battery compartment to make
sure + and – are in the proper position.
3. Put the battery cover back in place.
Important Battery Information
•
If you're not going to use the remote for a month or more, be sure to remove the batteries
because they can leak and cause damage.
•
Dispose of batteries in the proper manner, according to federal, state, and local regulations.
•
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all
batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to
charge a battery not intended to be recharged.
•
Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
Connections and Setup
2
4
3
Advertisement
Table of Contents
