Bosch PLT 2 Original Instructions Manual page 14

OBJ_BUCH-965-008.book Page 14 Thursday, October 22, 2015 9:46 AM
14 | English
Tile laser
2)3)
Laser line width
– at a distance of 3 m
– at a distance of 5 m
Batteries
Operating time, approx.
Weight according to
EPTA-Procedure 01:2014
Dimensions (length x width x height)
1)The working range can be decreased by unfavourable environmental conditions
(e.g. direct sun irradiation).
2)at 25 °C
3)The width of the laser line depends on the surface characteristics and on the ambient
conditions.
The measuring tool can be clearly identified with the serial number 4 on the type plate.
Assembly
Inserting/Replacing the Batteries
Alkali-manganese batteries are recommended for the measuring tool.
To open the battery lid 9, press on the latch 12 and fold the battery lid up. Insert
the batteries. When inserting, pay attention to the correct polarity according to
the representation on the inside of the battery compartment.
Always replace all batteries at the same time. Only use batteries from one brand
and with the identical capacity.
 Remove the batteries from the measuring tool when not using it for ex-
tended periods. When storing for extended periods, the batteries can cor-
rode and self-discharge.
Operation
Initial Operation
 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or variations
in temperature. As an example, do not leave it in vehicles for longer periods.
In case of large variations in temperature, allow the measuring tool to adjust
to the ambient temperature before putting it into operation.
 Avoid hard knocks to the measuring tool or dropping it. Damaging the
measuring tool can cause accuracy to be compromised. Following a hard
knock or fall, carry out a check by comparing the laser lines or plumb beams
with a known horizontal or vertical reference line or verified perpendicular
points.
Switching On and Off
To switch on the measuring tool, briefly press the On/Off switch 1. Immediately
after switching on, the measuring tool sends out the two laser lines at 0° and 90°.
 Do not point the laser beam at persons or animals and do not look into the
laser beam yourself, not even from a large distance.
To switch off the measuring tool, push the On/Off switch 1 again.
 Do not leave the switched-on measuring tool unattended and switch the
measuring tool off after use. Other persons could be blinded by the laser
beam.
To save energy, only switch the measuring tool on when you are using it.
1 609 92A 1J5 | (22.10.15)
PLT 2
<4 mm
<6 mm
3 x 1.5 V LR6 (AA)
15 h
0.36 kg
240 x 128 x 59 mm
Bosch Power Tools