Power And Ground Connection; General; Ac Power Input; Figure 3. Power Supply Vac-Select Switch - Motorola ASTRO Spectra Instruction Manual

Power and Ground
Connection

General

AC Power Input

6881086C22-B
All Consolettes should have a separate AC power circuit with proper current
and voltage for Consolette operation. Refer to the specifications section in the
front of this manual for AC requirements of each model. The power lines should
be installed in accordance with local electrical codes. A substantial earth
ground must be provided in a straight line close to the ground terminal provided
on the Consolette. DO NOT consider an electrical output box as a substantial
earth ground. See "Lightning and Surge Suppression" on page ix for additional
grounding recommendations.
Even if a three-wire grounding AC power source is
! !
available, the radio equipment must be grounded
separately to prevent electrical shock hazards and
W A R N I N G provide lightning protection.
The AC power line leading to the selected site for the Consolette may be
installed prior to installation of the Consolette itself.
The Consolette is shipped standard from the
factory for operation from a 115 VAC power
! !
source. For 230 VAC operation, remove the
Consolette top cover (see "Disassembly and
W A R N I N G
Reassembly" on page 38) and slide the AC power
selector switch, located on the Consolette power
supply, to the 230 VAC position. Install the
appropriate AC power connector on the end of the
115 VAC power cord provided with the Consolette.

Figure 3. Power Supply VAC-Select Switch

NOTE: Replacement 115 VAC power cords may be ordered from
Motorola as kit number HLN6282A.
Installation: Power and Ground Connection
VAC-Select Switch
7