Environmental Protection - Titan SF2841 Safety And Operating Manual

4. Reasons for different charging times.
Your charge time can be affected by many reasons
- which are not defects in your product. If the
battery pack is only partly discharged it may be
re-charged in less than 1 hour. If the battery pack
and ambient temperature are very cold then re-
charging may take 1 to 1 1/2 hours. If the battery
pack is very hot it will not re-charge because the
internal temperature safety cut-out will prevent it.
If hot you must remove your battery pack from
the charger and allow your battery pack to cool
first to ambient temperature and then recharging
can be started. If you charge a second battery pack
immediately after the first then the charger can
be over-heated. Always allow at least 15 minutes
rest between battery pack charging.
5. Reasons for different battery pack
working times
Charging time problems, as above, and having
not used a battery pack for a prolonged time will
reduce the battery pack working time. This can
be corrected after several charge and discharge
cycles by charging & working with your saw.
Do not re-charge your battery pack below 2
(36 F) and above 35
O
performance.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.
18V CIRCULAR SAW
SF2841 CSC18P-M-060425.indd 17
C (95 F), as this will affect
O O
C
O
SF2841
2006-5-25 11:08:49