Haier HDW13G1 User Manual page 27

Washing Results are not satisfactory
Problem
The dishes are not
clean.
Whitish streaks,
stains or bluish layers
on glasses and dishes.
Possible cause
Filters are clogged.
Filters are not correctly assem-
bled and installed.
Spray arms are clogged.
Programme was not applicable
for the type of load and food
remnants.
Incorrect position of the items
in the baskets. Water could not
wash all items.
Spray arms could not turn freely. Make sure that the position of the
quality of detergent in the deter-
gent dispenser.
The wash cycle was interrupted
by a long break.
Released quantity of rinse aid is
too much.
Quantity of detergent was too
much.
Combi detergent tablets used
with a short programme might
not fully dissolve.
Troubleshooting
Possible solution
correctly assembled and installed.
Remove remaining food remnants
with a thin pointed object.
Make sure that the programme is
applicable for the type of load and
food remnants.
Make sure that the position of the
items in the baskets is correct and
that the water can easily wash all
items.
items in the baskets is correct and
does not cause the blockage of the
spray arms.
Make sure that you add the correct
quantity detergent in the dispenser
before you start a programme
Do not open the door or cut power
supply during the wash cycle.
Decrease the
tity of rinse aid. Refer to section
DIFFERENT SETTINGS FOR RINSE
AID.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Select a longer programme when
using combi detergent tablets.
released quan-
26