Resetting Product Defaults; Reading Parameters; Aiming System - Datalogic Gryphon I GFS4400 Quick Reference Manual

Resetting Product Defaults

If you aren't sure what programming options are in your reader, or
you've changed some options and want your default settings
restored, scan the bar code below to reset the reader to its initial
configuration.
$P,HA00,P(CR)
The product can also be restored to its original factory default set-
tings. Reference the PRG for this option, and for a list of standard
factory settings.

Reading Parameters

Move the reader toward the target and center the aiming pattern
and illumination system to capture and decode the image. The aim-
ing system will briefly switch off after the acquisition time, and if no
code is decoded will switch on again before the next acquisition. The
illuminator will remain on until the symbol is decoded.

Aiming System

A number of options for customizing control of the Aiming System
are available. See the Gryphon I GFS4400 PRG for more information
and programming bar codes.
Quick Reference Guide
Defaults are based on the interface type. Be sure your
reader is configured for the correct interface before
scanning this label.
Reset Default Settings
Reading Parameters
7