To Remove The Dispenser; Door Alignment - Kenmore 795.71012.010 Service Manual

2) Press gasket into channels on the three remaining
sides of door.
3. Replace door frame cover
Starting at top of cover and working down, snap cover
back into door.

3-3 TO REMOVE THE DISPENSER

1. Use fiat tip screwdriver to pry back hooks on botton
underside of cover dispenser.
2. Pry off cover dispenser.
Figure 6
Disconnect wire harness.
3. Replace cover dispenser in opposite manner and order
of removal.

3-4 DOOR ALIGNMENT

If the space between your doors is uneven, follow the
instructions below to align the doors:
1. With one hand, lift up the door you want to raise at
middle hinge.
2. With other hand, use pliers to insert snap ring as shown.
3. Insert additional snap rings until the doors are aligned.
(Three snap rings are provided with unit.)
Figure 7
Figure 8
- 8 -
Figure 9
Figure 10