Setting Operation; Setting Atis Id Number - Raymarine Ray215e Owner's Handbook Manual

Operation with Full Function Handset

4.7.4 Setting Operation

This operation sets the function features of the RAY215E: the ATIS ID
number and on/off state, and the MMSI number.
1. Press the FUNC key followed by the MENU key to initiate the Menu
mode. Mn is shown on the 7-segment display and NAVSTAT appears
on the dot matrix display.
2. Press the SQ UP/DOWN key to select SETTING.
3. Press the ENT key. The message SET appears on the 7-segment display.
Pressing the SQ UP/DOWN key alternates between the following:
MY ATIS registers the ATIS ID number
MY MMSI registers the MMSI number
ATIS
Note: The ATIS selection only appears if this option has been enabled
by the dealer.
4. Select the desired operation and press the ENT key to submit your
selection.
4.7.4.1

Setting ATIS ID Number

This operation stores the ATIS number required for the Automatic
Transmission Identification System used in inland waterways of some
European countries. You can request an ATIS number when you apply for
a radio license.
Regulations in some regions may not allow end users to program their
own ATIS number. If this unit was purchased to be used in such a region,
this function will be disabled and the programming must be done by your
authorized Raymarine dealer/distributor.
Notes:
• This is a one time operation. Once the ATIS number has been
programmed, you will not be able to change it.
turns the ATIS function ON or OFF
ENT
4-53