Notes On Use - Siemens SIMATIC ET 200SP User Manual

2.1

Notes on use

Hazards at an unprotected machine or plant
According to the results of a risk analysis, hazards can occur at an unprotected machine.
The hazards may lead to personal injury.
According to the risk analysis, the risk of injury to persons can be countered with the
following measures:
• Additional protective equipment at the machine or plant. In this case, the programming,
• Use of the device for its intended purpose, which can be established by performing a
• Documentation of the test results which can be entered, if required, into the relevant
NOTICE
Ambient conditions
Ambient conditions for which the device is not suitable can lead to faults or damage the
device.
Note the following:
• Only operate the device in enclosed areas. If you do not comply with this instruction, the
• Only operate the device in accordance with the ambient conditions given in the technical
• Protect the device from dust, moisture and heat.
• Do not expose the device to direct sunlight or other strong sources of light.
• The device must not be used in places with more difficult operating conditions through
CPU 1515SP PC (F)
Manual, 05/2017, A5E32701806-AC
WARNING
parameter assignment and wiring of the I/O used, in particular, must be performed in
accordance with the safety criteria (SIL, PL or Cat.) ascertained by means of an
appropriate risk analysis.
functional test on the plant. This allows errors in programming, parameter assignment
and wiring to be detected.
safety certificates.
warranty becomes void.
specifications.
corrosive vapors or gases without taking additional protective measures, for example,
supply of clean air.
Safety notes
2.1 Notes on use
17