To mount the battery pack to a wall, take the following steps :
1. Mark the location on the wall for the holes.
2. Drill holes to suit fasteners in the wall.
3. Drive the fasteners through the mounting brackets into the holes
Recommended diameter : 10mm(0.4'') Min.
Recommended length : 70mm(2.8'') Min.
Recommended material : Stainless steel (8.8T)
Minimum fastener count : There must be at
least two fasteners in each of the four
mounting hole rows.
Minimum bolt clearance : At least 250mm(10'')
ex. Between Area1 last fastener
and Area2 first fastener
3. Installation