Programming Siemens Bmu Parameters - Siemens QAA73.210 User Manual

Setting
Note
User levels
Note
18 / 36
Siemens
Building Technologies
4.3

Programming Siemens BMU parameters

This functionallity is available only on some BMU's.
Buttons Explanation
1 Press the line selection buttons for at least 3 seconds.
This will take you directly to the programming level "Enduser".
2 The display shows a number of operating pages.
Press the line selection buttons to select the required
operating page.
To confirm, press OK.
3 The display shows a number of operating pages.
Press the line selection buttons to select the required
operating line.
To confirm, press OK.
4 The display shows the value flashing.
Press the line selection buttons until value is correct.
To confirm, press OK
5 By pressing the ESC button, you come back to operating
page selection.
6 By pressing the ESC button, you leave the programming
level.
If no button is pressed for about 1 minutes, the room unit will automatically leave
programming level.
The user levels only allow authorized user groups to make settings. To reach the
required user level, proceed as follows:
Buttons Explanation
1 Press the line selection buttons for at least 3 seconds.
This will take you directly to the programming level "Enduser".
2 Press the Info button for at least 3 seconds.
This will take you to the user level selection.
3 You are now given a choice of user levels.
Press the line selection buttons to select the required user
level.
To confirm, press OK. You are now on the required user level.
The following user levels are available
USR = End user
INST = Heating engineer
OEM = OEM
To reach the OEM level, the relevant code must be entered.
For detailed information, please refer to the technical documentation of the boiler
controller used.
Room Unit for Boiler Control
Handling
CE1U2283en
2015-09-16