Cabinet Installation; Audio/Video In Jacks - Philips PR0930X1 Owner's Manual

Color television and remote control
Table of Contents

Advertisement

H
U
OOKING
C
I
ABINET
NSTALLATION
C
I
ABINET
NSTALLATION
I
M
NSTALLATION SUR UN
EUBLE
holes through the under-
F
ollow the instructions below
side of the cabinet using the
to install the TV beneath a
six circles on the swivel base
kitchen cabinet. But, before
(supplied) as guides.
beginning, review the tips on
page eight.
Percer six trous de 1/4 de
pouce dans le dessous du
S
uivre les instructions
meuble en se guidant à
ci-dessous pour installer le
l'aide des six cercles sur la
téléviseur en-dessous d'un meu-
base pivotante (fournie).
ble de cuisine. Mais avant de
commencer, revoir les conseils
de la page 8.
Washer
Hexagonal Nut
4 mm x 18 mm
Screws
CAUTION: To reduce the risk of fire, do not place any heating or cooking appliances beneath this unit.
ATTENTION: Afin de réduire les risques d'incendie, ne placer aucun appareil chauffant ou de cuisson en-dessous de cette unité.
NOTE:
Screws that are too short will not screw far enough into the nuts to securely hold
the TV. Screws that are too long will protrude below the base of the cabinet and
may scratch the TV when it is swiveled.
REMARQUE: Des vis trop courtes ne se visseront pas suffisamment profondément dans les
écrous pour maintenir le téléviseur en toute sécurité. Des vis trop longues
dépasseront de la base du meuble et pourront rayer le téléviseur lorsque il pivotera.
NOTE:
Route and arrange the excess AC cord as illustrated at right so it will not drape
where it can be pulled on or tripped over.
REMARQUE: Acheminer et arranger le cordon CA en excès, comme montré dans l'illustration,
de telle sorte qu'il ne puisee pas être tiré ou accroché.
U
F
A
SING THE
RONT
UDIO
A
/V
I
J
UDIO
IDEO
N
ACKS
cable (not supplied) to the
F
or more convenient tape
VIDEO OUT jack of the
playback from a camcorder
camcorder/VCR and to the
or VCR, use the AUDIO and
VIDEO In jack on the front
VIDEO In jacks on the front of
of the TV.
the TV. These easily accessible
jacks allow quick connections
between the TV and the VCR
or camcorder.
VIDEO
Y
TV (A
P
OUR
NTENNA
/ I
NSTALLATION SUR UN
Drill six 1/4-inch
Attach the swivel base
to the cabinet using six of
each of the following: screws,
washers, and hexagonal nuts
(supplied). Refer to the draw-
ing shown below.
Fixer la base pivotante au
meuble à l'aide des six vis,
rondelles et écrous hexago-
naux (fournis). Référez vous au
dessin ci dessous.
5 mm x 40 mm
Screw
Swivel Base
TV
/V
I
J
IDEO
N
ACKS
Connect a video
Connect an audio cable
(not supplied) to the
AUDIO OUT jack of the
camcorder/VCR and to the
AUDIO In jack on the
front of the TV.
AUDIO
OUT
Audio Cable (white) from
AUDIO OUT to AUDIO
Video Cable (yellow) from
VIDEO OUT to VIDEO
/C
C
ABLE
ONNECTIONS
M
EUBLE
Slide the TV onto the
hook on the swivel base
and push it backward until
the TV locks into place.
Faire glisser le téléviseur
sur le crochet de la base
pivotante et le repousser
jusqu'à ce que le téléviseur
se verrouille en place.
Secure the TV to the
swivel base using two
5/32"(4mm) x 11/16"(18mm)
screws (supplied).
Fixer le téléviseur sur la
base pivotante à l'aide de
deux vis de 5/32"(4mm) x
11/16"(18mm) (fournies).

Cabinet Installation

• Keep in mind your normal work pattern, especially the way in
which you use other electrical appliances, when you are thinking
about where to install the TV.
• Hold the TV in various locations. In each location, turn the TV on
so you may check reception.
• If you are going to use the rod antenna, allow enough space around
the TV to extend and adjust the antenna.
• Make sure the TV is close enough to an electrical outlet that the
power cord can reach it.
• Allow enough room on all sides of the TV for ventilation, access to
control knobs, and room to swivel the TV for ease of viewing.
• Route and arrange the excess AC cord so that it will not drape
where it can be pulled on or tripped over unintentionally.
Press the TV/AUX but-
ton on the TV remote con-
trol to put the TV in
Auxiliary In mode.
Turn on the cam-
corder/VCR and press the
PLAY button on the cam-
corder/VCR.
When you are finished
watching the tape, press
the STOP button on the
camcorder/VCR.
AUDIO
VIDEO
MENU
VOLUME
EARPHONE
- 4 -
) (C
'
ONT
D
S
MART
H
ELP
Make sure
the area directly
beneath the TV is
not used for cook-
ing and does not
contain an appliance
that generates heat
or steam.
Veiller à ce que la
zone directement
en-dessous du
téléviseur ne soit
pas utilisée pour
cuire et ne conti-
enne pas d'appareils
générateurs de
chaleur ou de
vapeur.
Wire Tie
Power Cord
AC 120V
S
MART
H
ELP
When you are
finished watching
the tape, press the
TV/AUX button on
the TV remote con-
trol to return to
viewing normal TV
channels.
If the VCR or cam-
corder has Right
and Left AUDIO
OUT jacks, you will
need a "Y" connec-
tor cable in order
to connect the cam-
corder/VCR to the
TV. Or, check the
owner's manual of
the camcorder or
VCR. It may explain
how to connect to
a TV that has a sin-
gle AUDIO In jack.
)
ANT. IN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents