Optional Accessories - Makita BUH550 Instruction Manual

blades to the periphery of the crank.
Fig.21
Overlap the oval hole in the upper blade with that in the
lower one.
Fig.22
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
Fig.23
Place the new shear blades on the tool so that the oval
holes in the shear blades fit onto the crank. Overlap the
holes in the shear blades with the screw holes in the
tool and then secure them with two screws.
Fig.24
Check the crank for smooth turn with a slotted bit
screwdriver.
Fig.25
Install the plate, under cover on the tool. Tighten the
screw firmly.
NOTE:
There is no distinction between the top and bottom
•
of the plate.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
Replacing carbon brushes
Fig.26
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.27
Insert the top end of slotted bit screwdriver into the
notch in the tool and remove the holder cap cover by
lifting it up.
Fig.28
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Reinstall the holder cap cover on the tool.
Storage
The hook hole in the bottom of the blade cover is
convenient for hanging the tool from a nail or screw on
the wall.
Fig.29
Remove the battery cartridge and put the blade cover
on the shear blades so that the blades are not exposed.
Store the tool out of the reach of children carefully.
Store the tool in the place not exposed to water and rain.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Blade cover
•
Shear blade assembly
•
Makita genuine battery and charger
•
Battery adapter
•
Arm cord hook (to be used together with the
•
battery adapter)
Chip receiver
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
12
or attachments
Only use accessory or
are