Program Schedule Overrides - Honeywell T6 Pro Z-Wave User Manual

Program schedule overrides

If the thermostat is included in Z-Wave network it typically follows the setting on your
Z-Wave controller. If you adjust the temperature setpoint, it overrides the current
setpoint until away state or new temperature setpoint is received from Z-Wave
controller. Setting of Hold until time and Permanent hold (see below) will not be
available on the thermostat screen.
If the thermostat is not included in the Z-Wave network and the thermostat is
following time based schedule, you can set what time the new temperature setpoint
will be held until or you can hold the new setpoint permanently.
There are several scheduling options available for the thermostat. For more
information go to page 12.
Program schedule override (temporary)
1 Touch or
screen to set your desired temperature. Hold
Until will appear together with the time the
hold will end.
2 To change when the hold will end, touch the
time and wait until the time starts blinking.
Then, touch
the hold to end. Touch Hold Until once more
to confirm changes and return to the home
screen.
After the hold period ends, the thermostat will
automatically return to the program schedule. If
you want to cancel the hold, touch Hold Until and
then touch Run Schedule.
Program schedule override (perma-
nent)
1 Touch or
screen to reach your desired temperature.
Hold Until will appear together with the time
you want the hold to end.
2 Touch Hold Until. Permanent Hold will appear
on screen. Touch Permanent Hold to hold this
temperature until you manually change it.
To end permanent hold and return to the
program schedule, touch Permanent Hold and then
touch Run Schedule.
on the thermostat home
or to set when you want
on the thermostat home
5
Heat On AM
Hold Until
AM
Mode Fan
Heat Auto
Mode Menu Fan
AM
Permanent Hold Hold Until
AM
Run Schedule
Back
Heat On AM
Hold Until
AM
Mode Fan
Heat Auto
Mode Menu Fan
AM
Permanent Hold Hold Until
AM
Run Schedule
Back