Oven Check; Fitting The Plinth; Customer Care; Thank You - Rangemaster U102210-04 User Manual & Installation & Service Instructions

This shows the single-phase connection.
the mains cable to the correct terminals for your
electrical supply type (see fi g.). Check that the links are
correctly fi tted and that the terminal screws are tight.
Secure the mains cable using the cable clamp.
These appliances are of type X with regard to protection
against over heating of the surrounding surfaces.
Current Operated Earth Leakage
Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
100mA device. This work should be carried out by a
qualifi ed electrician

Fitting the plinth

Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fi t each end keyhole over their respective
screws. Tighten the fi xing screws.
Oven Light
Press the oven light switch and check that the light is
working.
NB The oven light bulb is not included in the
guarantee
Hobplate
Turn on each plate in turn and check that it heats up.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.

Oven check

The clock must be set to the time of day before the
ovens will work.
Press and hold as above.
At the same time, press - or + until the correct time
shows.
Don't forget it's a 24 hour clock.
If you make a mistake or press the wrong button, turn
off the power supply for a minute or two and start again.
Turn on the oven and check that the oven fan starts
to turn and that the oven starts to heat up. Turn off the
oven.

Customer care

Please complete your details in this Guide, inform the
user how to operate the cooker and hand over the
Instructions.

Thank you.

24