Table of Contents
Advertisement
Main Menu
Tone-Out-For
Sub Menu
Weather Alert
Review WX Alerts
Program SAME
Set Delay Time
Set Attenuator
WX Alt Priority
Tone-Out Standby
Tone-Out Setup
30
Setting or Sub-sub
menu
Select how the scanner responds to weather
alerts:
• Alert Only the scanner responds to any alert
received when it detects the 1050 Hz alert
tone
• SAME 0-4 the scanner only responds to an
alert if it matches the selected stored SAME
settings.
• All FIPS the scanner responds to any alert
and displays the received event code.
Select a past alert to hear the audio of the
alert.
Select one of the SAME slots, then set a
name and county for the slot. You will need to
know the FIPS code for the county you want
to enter. FIPS codes can be found on NOAA's
web site.
Sets how long the scanner remains on a
weather channel after the signal is lost before
scanning weather channels.
Turns attenuation on/off for weather channels.
When turned on, the scanner will check for a
1050Hz tone on the current weather channel
every 5 seconds while scanning. Note that
this interrupts any existing voice traffic.
Select this and the scanner will go into tone-
out standby mode. Scroll to select the tone-
out settings to use. If multiple settings use the
same RF settings but different tone settings,
all matching settings are used. No other
function works while the scanner is in tone-out
standby mode.
Scroll to select the tone-out settings you want
to edit, then use the below menu items to
change settings:
Edit Name
Set Frequency
Setting
Set the alpha tag for
the tone-out settings
Set the RF frequency,
Modulation, and
Attenuation settings.
Advertisement
Table of Contents
