Periodic Maintenance Procedures
Fit the spark plug cap [A] so that it is aligned with the line
[B] on the cylinder head cover.
Pull up the plug cap to make sure the installation of the
spark plug cap.
Install the removed parts (see appropriate chapters).
Spark Plug Replacement
Refer to the Spark Plug Cleaning and Inspection.
General Lubrication and Cable Inspection
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
Lubricate the points listed below with indicated lubricant.
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
Points: Lubricate with Grease.
Clutch Inner Cable Upper and Lower Ends [A]
Throttle Inner Cable Upper End
Brake Lever Pivot Bolt
Clutch Lever Pivot Bolt
Brake Pedal Bolt
Cables: Lubricate with Rust Inhibitor.
Throttle Inner Cables
Clutch Inner Cable
Pivots: Lubricate with engine oil.
Rear Master Cylinder Joint Pin
PERIODIC MAINTENANCE 2-77