Periodic Maintenance Procedures
Remove the cylinder unit [A] from the outer tube [B].
Do not make the piston rod contact to the outer
tube. The piston rod could be damage. Disassem-
bling the cylinder unit can cause internal damage.
Do not disassemble the cylinder unit.
Drain the fork oil [A] from the cylinder unit by pumping the
piston rod [B] more than 10 times.
Service carefully because oil flies out from the oil hole
of the cylinder unit.
Hold the front fork at the inverted position for more than
20 minutes to allow the fork oil to fully drain.
With the piston rod fully stretched, pour the fork oil [A] of
50 mL (1.69 US oz.) into the cylinder unit [B].
Suspension Oil - SS-19 (1 L): 44091-0009
Replace the O-rings [A] on the chamber cap [B] and cylin-
der unit [C] with new ones.
Apply teflon grease to the O-rings on the chamber cap.
Install the chamber cap to the cylinder unit.
PERIODIC MAINTENANCE 2-61